Why is The Base of My Toliet Leaking?

Is there standing water at the base of your toilet? If that’s the case, it’s not a good indicator. This indicates that there is a leak in your toilet, most commonly towards the base of the fixture. Instead of letting your bathroom turn into an indoor swimming pool, get out your favourite tool belt and begin repairing that leak!

THE TEE BOLTS COULD BE LOOSE

Do you remember the plastic caps that go around the base of your toilet? Those covers are concealing tee bolts, which assist keep your toilet in place. When these bolts become loose or damaged, the toilet’s seal might break, resulting in leaks. Tighten the bolts after repositioning your toilet so that it is level and centered. If the bolts continue to spin freely or are damaged, take them to the store and get a new set.

YOUR TOILET MAY HAVE A BROKEN WAX RING

You’ve examined your tee bolts and attempted to tighten them, but your toilet is still leaking at the base. The most likely culprit is the wax ring, which will need to be changed.
Go to the store and get yourself a new wax ring for your toilet. If possible, take a picture of the toilet’s base and ask a store employee to assist you in finding a comparable replacement.
Start by turning off the water to your toilet using the water valve found behind the toilet. Then flush the toilet to eliminate as much of the standing water as possible. To remove any remaining water, loosen the nut that holds the fill valve in place and collect the surplus with a small pail. Finally, drain any remaining water from the toilet’s base by plunging it for a few seconds.
Remove the Toilet and Old Wax Ring – Unscrew the water supply line from the toilet and unscrew the floor tee bolts. The toilet should now be raised and relocated from its customary location. Place the toilet on its side and begin removing the old wax ring. Before inserting the replacement wax ring, make sure you remove any dried-on wax and residue.
Install the New Wax Ring – Place the freshly purchased wax ring over the flange and secure it with the tee bolts. Reposition your toilet in its customary location after installing the new wax ring.
Reinstall Your Toilet – Make sure the toilet is in the proper position before pushing it into the wax ring to form the new seal. Screw the tee bolts into place (be careful not to overtighten), having in mind that the toilet must be correctly centered and balanced. Reconnect your water line, reopen the valve, and flush it. Examine your toilet carefully to determine if any water is leaking from the new seal.
A toilet leak can cause mould to grow and raise water costs, therefore any leak should be repaired right once. If you want your toilet repairs to be done as perfectly as possible, contact your local plumber.
When you need a plumber to repair your toilet with precision in the Melbourne area, contact SWR Plumbing.